Solid timber kitchen counters are natural items made of timber from trees approximately 120 years old. Timber is a living material and also the more wetness obtains, the much more the timber kitchen counter will broaden. The timber we used in solid timber worktops has actually been previously kiln dried to a moisture degree of 6%, and it is consequently important that the worktop is not subjected to a frequently high level of humidity. Usually the moisture degree in cooking areas is approximately 50-70%.
The solid wood top need to be connected to the cabinet box using only wood screws as well as washing machines. It is not advised in all to adhesive the top on the cabinet box; the leading as well as the box expand and contract at various prices, consequently splits may ultimately appear, most likely on the closets' surface area.
The appropriate way of installing a strong timber top is utilizing metal repairings along the cabinet box (see our internet page).
The metal repairings must be evenly distributed throughout the size of the top, spaced at a 1' - 1.5' range from each other. Throughout the width, the top is generally taken care of to each metal assistance with three screws, one in the center, one toward the front side as well as one towards the rear side. The supports have to be completely leveled; or else tensions can create in the wood, causing warping, cupping, or fractures.
We recommend pre-drilling the screw holes right into the wood counter top, in order to avoid fractures and also splits. For the exact same factor, it is a good concept not to over tighten up the screws. The finishing will significantly lessen the extent of such motions, yet will not eliminate them entirely. As a result of the panel's laminated framework, the lengthwise movements are irrelevant, so the installer needs to focus on the motions taking place across the panel's width. In order to avoid the advancement of internal stress, live edge dining table the openings in the steel correctings should be extended in the direction of the movements (see our websites ).
When exposed to normal humidity levels - i.e. 50-60% - the worktop's size will certainly increase by 1/12"-1/ 24", yet when revealed to a degree of 80-90%, this dimension may broaden by up to 1/2" and even more for some species. Therefore, when the back side of the counter top is set up against a wall, the wall surface may restrict the top's natural activities, bring about unwanted tensions in the timber. To prevent this, you can enable a 1/4"-1/ 2" joint between the wall surface as well as the countertop side as well as caulk it with a thin proposal of acid-free silicone.
In addition, you can firmly fix the back edge to the steel supports below as well as thus, permit the natural activities to happen at the expenditure of the opposite side.
In this case, the holes in the metal repairings matching to the rear side will be no bigger than the screws diameter, while the holes matching to the middle area and the front side will certainly be elongated.
For added information pertaining to the installation of timber kitchen counters, bar tops as well as kitchen islands, please see our internet page.